Home
NLR News
Contact Information
Shop NLR
Account
Back
Log in
Create account
My Profile
Home
Sensors, Billet Mounts, adapters etc
Sensors, Billet Mounts, adapters etc
$175.00
Details
Davis Technologies Wheelspeed Sensor DAV-001
Perfect for front wheel speed or driveshaft. These can be used on the factory OEM tone ring for abs which is where you want to put it for MPH based boost or nitrous control.
$25.00
Details
Ams-2000 Main Connector
Connector for main harness
$179.00
Details
100 psi integrated harness sensor
This sensor features no connector on the end which makes it perfect for waste gate pressure or anything with high vibration. The harness is terminated inside of the sensor and then encapsulated and sealed. This offers incredible vibration resistance since there is no connection at the sensor. Stainless steel construction with 1/8 npt male thread. Harness lead extends 18 inches from sensor where you can put your dtm connector or connector of choice.
$130.00
Details
AMS-2000 Billet Mount for 1 5/8 Roll Bar
Billet ams2000 mount for 1 5/8 roll bar. Remote switch can mount on the front of it.
$124.99
Details
Motion Raceworks Driveshaft Sensor 18 tooth collar
Motion Raceworks High Resolution Driveshaft Speed Wheel offers amazing quality driveshaft speed data with a high resolution approach to help smooth out your graph and deliver accurate data to your recording device or traction control. Our billet steel collar offers 18 pickup points for a hall effect pickup that reduces noise and allows for all of the benefits of a square wave signal. This piece is TRACK PROVEN and we only suggest purchasing this if you like to crush the competition! MRW driveshaft wheel can be utilized with nearly any data collection system as well as any EFI system. As long as your system allows for a hall effect pickup you are good to go! This collar comes with ID for all standard pinion yokes produced by nearly all manufacturers. The sizes below reflect the flat surface OD on your pinion which will match the collar ID. 1.812 1.875 2.125 2.187 2.5 (strange 8.8 yoke) Available for 8.8 (8.8 yoke sizing 2.5 inches is based off of the strange 8.8 chrome moly strange yoke ) and 9 inch rear end.
$165.00
Details
Can Bus Adapter for AMS-2000 Boost or Nitrous box
For factory ecu vehicles from 2006+ This will provide wheelspeed as well as engine rpm to the AMS2000 for speed output and engine rpm output. Some vehicles will be front wheel and some will be rear wheel. Depending on what the manufacture programs for the can bus to read.
$1.00
Details
Terminal for AMS-2000's
Terminal for main connector .
$15.00
Details
Connector for Sensor
Connector for Sensor
$349.00
Details
Remote Switch
Remote Switch
$90.00
Details
Solenoids
$200.00
Details
Solenoid Block with Solenoids
NLR designed solenoid package. Response and flow are fundamental as well as a fantastic layout for lines and mounting. This combination with 100 psi input pressure can stack 80 psi on 2- 60mm gates with 6 ft line length in .28 seconds.
$25.00
Details
AMS-1000 Harness
AMS-1000 Harness does not come with terminals as they are no longer made. The terminal strips on the ams1000 and ams500v2 are designed to be used with bare wire or terminals.
$125.00
Details
AMS-2000 Harness (No Remote Switch)
AMS2000 Harness (No Remote Switch)
Powered by NLRSystems.com site by asmoody70@gmail.com
Copyright © 2015 - 2022
NLRSystems.com
NLR
Facebook
YouTube