Shop NLR Systems
Software and Manuals
Sensors, Billet Mounts, adapters etc
AMS/NMS-1000/2000 Upgrade Packages
Air Systems and Co2 Regulators
Apparel and Decals
Motorcycle Race Parts
Hang Gliding Parts
ams2000 NITROUS CONTROLLER
There is no need to call as we will be unable to tell you when we will have more. We have been waiting for 22 months for processors and have no idea when they will be delivered. We will update here as soon as we have info.
ams2000 boost controllers
There is no need to call or email regarding when we will have more. We cannot answer that as have been waiting 22 months for processors. When we get information we will update the website.
NLR GEn X Plenum
Davis Technologies Wheelspeed Sensor DAV-001
Perfect for front wheel speed or driveshaft. These can be used on the factory OEM tone ring for abs which is where you want to put it for MPH based boost or nitrous control.
READ BELOW BEFORE DOWNLOADING V7-4 NEW AS OF 5/25/2022
Please READ EVERYTHING HERE so you don't call 50 times because you didn't read this ;) To get to the download click ADD TO CART, then CONTINUE TO CHECKOUT, then COMPLETE ORDER and it will be on the next page that shows up. You are not being charged anything. In order to host the download in our store it has to simulate a purchase in order to get to the download page. --------------FIRMWARE UPDATE REQUIRED-------------------------- The firmware file is in this download folder as well as software. 1st page of the manual scroll down to Software and Firmware updating for instructions on how to do it or watch this video https://youtu.be/8lhwu6pVpYo ----------------BOOST CONTROLLER USERS PLEASE NOTE-------------- This Software and Firmware has another level of sensor fault testing. If your using the aux channel for co2 pressure control(with a sensor connected to aux channel), relay driver, or anything else you can ignore this!! If your not using it for anything do the following. Connect with your existing software to your ams2000 and do the following. 1. CLICK SYSTEM TAB AND THEN OUTPUT FUNCTIONS 2. CLICK OUTPUT 3 AND SELECT DISABLE 3. HIT FILE AND SAVE TO AMS2000 4. NOW YOU CAN INSTALL THIS SOFTWARE AND CONTINUE BY FOLLOWING THE INSTRUCTIONS IN THE MANUAL If you dont do the above and use the new software and firmware please dont be alarmed if you get a sensor error code show up. If you have the aux channel set to pressure and do not have a pressure sensor connected to it this is why your getting this error. Go to systems, output functions and click on the output 3 where it says pressure. Select disable and send the tune up to ams2000. That will clear it. If you've got that channel controlling pressure its going to want to see a sensor connected to it or it will trigger a warning like this.
Powered by NLRSystems.com site by email@example.com
Copyright © 2015 - 2022