Nitrous Controllers

Each output can be programmed with a different frequency(HZ) and is adjustable from 3 hz to 1000hz in .10 increments for absolute control. This means that you could run 2 wet kits and run different hz on both fuel and nitrous solenoids. The PRO UNIT can do any type of control as well BUT it can combine and modify the main curve based on any of the other inputs coming into it. You can make it a simple time based table or a time based table that adds or subtracts based on back pressure before the solenoid and/or pressure drop after the solenoid. You could adjust your curves based off fuel pressure as an example. You could do a speed based set up on a late model vehicle using our can bus adapter(pro or base) all while taking advantage of the built in rpm windows etc. Our speed based control is based off of undriven wheelspeed so rear tires spinning doesnt effect it. It is limitless with the PRO unit. The tables are easy to use and understand. Analog outputs are smooth and precise which makes fuel control on a dry kit fantastic ! With the pro unit there are 2 of them so you can have 2 fuel compensations running if needed OR control something based off the nitrous control. The 5 position switch is an absolute must. Thinking your going to carry a tablet in your car and make a change right after the burnout is crazy. You going to take your gloves off and fumble around? Doubt it. You need to be able to make a last minute change with gloves on. The 2000 allows you to make that last second split decision which alot of times determines if your going home or going to the next round. Pro Unit includes: 2 nitrous outputs 2 fuel outputs 2 analog outputs or you can configure it for 1 nitrous output 1 fuel output 1 analog output 2 relay drivers 1 remote selector switch to switch between 5 tunes G-meter Datalogging Offset capability Other tools available by code are PWM tables with super trick thresholds that you can use for whatever you want. If at a later date you want the turbo program all you have to do is call up and purchase it. Its a code and now you have a controller that capable of both without having to purchase and rewire.

The 2000 base unit can do nitrous control based on pretty much anything you can think of. TPS,Speed, time, engine rpm, boost, gear,Shift input, air fuel, a 0-5 volt input or whatever you can imagine as the inputs are designed to be configurable. It can be updated to a PRO unit at any time by code which mean you can get in on a lower cost point yet still having the same hardware in your unit so you dont have to buy another box later. The hardware and features are locked out until it is PRO enabled. The 5 position switch is an absolute must. Thinking your going to carry a tablet in your car and make a change right after the burnout is crazy. You going to take your gloves off and fumble around? Doubt it. You need to be able to make a last minute change with gloves on. The 2000 allows you to make that last second split decision which alot of times determines if your going home or going to the next round. Base unit includes: 1 nitrous output 1 fuel output 1 analog output 1 relay drivers ( trigger retards ) 1 remote selector switch to switch between 5 tunes NO Gmeter NO Logging NO Offset capability If at a later date you want the turbo program all you have to do is call up and purchase it. Its a code and now you have a controller that capable of both without having to purchase and rewire.

Looks almost identical to the AMS-1000 ! No laptop is needed and an easy to use user interface is built in!